Using the Intel® RealSense™ Depth cameras D4xx in Multi-Camera Co
Download Whitepaper
Using the Intel® RealSense™ Depth cameras D4xx in Multi-Camera Co
- Author:
Anders Grunnet-Jepsen, Paul Winer, Aki Takagi, John Sweetser, Kevin Zhao, Tri Khuong, Dan Nie, John Woodfil
Multiple cameras can be connected to a PC and will be able to stream independent data. The cameras operate in the “Default” mode and will stream asynchronously. However, if it is desired to hardware synchronize (e.g. HW sync) them so they capture at exactly the same time and rate, the cameras will need to be connected via sync cables, and will need to be configured in software to have a single master (or an externally generated sync signal) and multiple slaves. The connector port can be found on the cameras as shown below, and a cable will need to be assembled. This is basically only two cables that need to be connected from master to slave unit, in the simplest design
